Using Oneclick Internet; Using Connection Manager - Honeywell Marathon User Manual

Using OneClick Internet

If OneClick Internet is inactive, double tap the desktop icon to load it.
When OneClick Internet is active but minimized to the system tray, tap the OneClick Internet status icon in the system tray to
maximize it.

Using Connection Manager

1. Launch the OneClick Internet Connection Manager and wait until the status icon is Blue indicating ready.
2. If there is a problem, verify the SIM card is installed (AT&T, T-Mobile only), the proper firmware has been loaded, etc.
3. If Pin security is used, a popup window prompts for the SIM PIN.
4. Create a connection profile on the Settings menu.
5. Tap the Connect button.
6. When OneClick Internet is opened and not yet connected, the Connect button is green. When OneClick Internet is
connecting, the Connect button changes to a yellow Cancel button. When OneClick Internet is connected, the Connect
button changes to a red Disconnect button. When OneClick Internet cannot connect and times out, the Connect button
does not change color.
After a successful connection, the main screen opens. signal strength is indicated in the top left corner, as well as the name
of the mobile network you are using. General windows controls for minimize and exit are located at the upper right of the
main screen.
The Status light below the Connect button indicates the current status of the WWAN signal:
Ready. Tap the Connect button to establish a connection.
Connecting. Tap the Cancel button to cancel the connection in process.
Connected. Tap the Disconnect button to end the connection.
Failure. Review the screen for messages such as "No Network", etc.
8 - 5