Honeywell Marathon User Manual page 113

WPA/LEAP
To use WPA/LEAP, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile.
2. Set EAP Type to LEAP.
3. Set Encryption to WPA TKIP.
4. Set Auth Type as follows:
• If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio setting to Open.
• If the AP is configured to use shared key or passphrase, set the Auth Type radio setting to Shared.
• If the AP is configured for network EAP only, set the Auth Type radio setting to LEAP.
5. To use another encryption type, select WPA CCKM, WPA2 AES or WPA2 CCKM for encryption and complete
other entries as detailed in this section.
6. See Sign-On vs. Stored Credentials
7. To use Stored Credentials, click on the Credentials button. No entries are necessary for Sign-On Credentials as
the user will be prompted for the Username and Password when connecting to the network.
8. Enter the Domain\Username (if the Domain is required), otherwise enter the Username.
9. Enter the password.
10. Click OK then click the Commit button. Ensure the correct Active Profile is selected on the Main tab and restart.
The SCU Main tab shows the device is associated after the radio connects to the network.
(page 6-52) for information on entering credentials.
6 - 63