Multitech etherFAX A2E User Manual page 11

Field
Send
Receive
Skip Lines
Reporting
Caller ID
Poll Interval
Advanced Configuration
To open this form, click Advanced Configuration on the lower left corner of the System Settings form.
Setting
Proxy Server
User
Password
®
etherFAX A2E MT200A2E-EF User Guide
Description
Enables the device for send fax functionality.
Enables the device for receive fax functionality.
Defines number of raster lines to remove from top of a page. Use this to drop the
analog fax device's header and replace it with an etherFAX supplied header.
Sets transmission report type. Reports will be printed by the local analog fax
device. Options are:
■
Errors only — Sends report if transmission fails.
■
Always — Sends a report for every transmission.
■
Never — Never sends a transmission report. You can view failed
transmission in the etherFAX Client Portal, under Reporting.
Important: Disable transmission reports on the analog fax device as the
etherFAX A2E generates these reports.
Configures the caller ID for etherFax A2E to use when sending a fax.
Note: Configure Caller ID as a valid 10 digit toll number. Failure to do so
results in higher transmission failure rates.
Integer value, in seconds, that the etherFAX A2E polls the etherFAX service for
inbound faxes.
Description
IP or hostname address to use for connection if proxy server is required.
User name to supply if proxy server is required.
Password to supply if proxy server is required.
CONFIGURING THE DEVICE
11