At+Qgpscfg="Speed_Threshold" Configure Speed And Distance Thresholds - Quectel LPWA Series BG96 Application Note

AT+QGPSCFG="autogps" Enable/Disable GNSS to Run Automatically
Write Command
AT+QGPSCFG="autogps"[,<autoGPS
>]
Maximum Response Time
Characteristics
Reference
Parameter
<autoGPS> Integer type. Enables/disables GNSS to run automatically after the module is powered
on.
0 Disable GNSS to run automatically
1 Enable GNSS to run automatically
<errcode> Integer type. Error code of operation. See Chapter 4 for details.
NOTE
This command is valid only when the GNSS works in stand-alone mode.
2.2.1.10.

AT+QGPSCFG="speed_threshold" Configure Speed and Distance Thresholds

This command configures the speed and distance thresholds.
AT+QGPSCFG="speed_threshold"
Write Command
AT+QGPSCFG="speed_threshold"[,<
speed_threshold>[,<distance_thresh
old>]]
BG96_GNSS_Application_Note
Response
If the optional parameter is omitted, query the current setting:
+QGPSCFG: "autogps",<autoGPS>
OK
If the optional parameter is specified, set whether to enable
automatic running of GNSS:
OK
If there is any error related to ME functionality:
+CME ERROR: <errcode>
300 ms
The command takes effect after rebooting.
The configuration is saved automatically.
Configure Speed and Distance Thresholds
Response
If <speed_threshold> and <distance_threshold> are both
omitted, query the current setting:
+QGPSCFG: "speed_threshold",<speed_threshold>,<di
LPWA Module Series
BG96 GNSS Application Note
19 / 42