At+Qgpscfg="Gnssconfig" Configure Supported Gnss Constellation; At+Qgpscfg="Autogps" Enable/Disable Gnss To Run Automatically - Quectel LPWA Series BG96 Application Note

2.2.1.8.

AT+QGPSCFG="gnssconfig" Configure Supported GNSS Constellation

The command configures the supported GNSS constellations of the module.
AT+QGPSCFG="gnssconfig" Configure Supported GNSS Constellation
Write Command
AT+QGPSCFG="gnssconfig"[,<GNSS
_config>]
Maximum Response Time
Characteristics
Reference
Parameter
<GNSS_config>
<errcode>
2.2.1.9.

AT+QGPSCFG="autogps" Enable/Disable GNSS to Run Automatically

The command configures whether to enable automatic running of GNSS after the module is powered on.
BG96_GNSS_Application_Note
Response
If the optional parameter is omitted, query the current setting:
+QGPSCFG: "gnssconfig",<GNSS_config>
OK
If the optional parameter is specified, set the supported GNSS
constellations:
OK
If there is any error related to ME functionality:
+CME ERROR: <errcode>
300 ms
The command takes effect after rebooting.
The configuration is saved automatically.
Integer type. Supported GNSS constellation.
GPS is always ON.
0 GLONASS OFF/BeiDou OFF/Galileo OFF
1 GLONASS ON/BeiDou ON/Galileo ON
2 GLONASS ON/BeiDou ON/Galileo OFF
3 GLONASS ON/BeiDou OFF/Galileo ON
4 GLONASS ON/BeiDou OFF/Galileo OFF
5 GLONASS OFF/BeiDou ON/Galileo ON
6 GLONASS OFF/BeiDou OFF/Galileo ON
Integer type. Error code of operation. See Chapter 4 for details.
LPWA Module Series
BG96 GNSS Application Note
18 / 42