Table of Contents
Advertisement
2
GENERAL REMARKS
This manual intends to provide essential information for the installation, use and maintenance of the
product Sensopress LCD.
It's important that the user and / or installer reads this manual in all its parts before installing
and using the product.
An improper use may lead to failures and loss of guarantee.
Please always specify the
for technical information or spare parts to our trade and assistance service.
there are to be requested technical information or spare parts
For instructions, situations and events not covered by this manual, please contact the customer
service.
Sensopress LCD is a measuring and high-tech electronic level controller that can be used in sandy
drinkable waters, in liquid food products or if availing oneself with an adequate plant design, it can
also be used in filthy waters or corrosive liquids.
The measurement is committed by a very perceptible pressure sensor. Its signal once transformed
and elaborated by a microcontroller is converted in "height of water column" measured in water cm.
Note: all the visualized values are in mBar. The correct value in water cm is obtained by augmenting
the pressure in mBar of 2 % (1.973 % a 4°C).
Sensopress LCD can be produced in two versions: with a single output or with 4 outputs in the
multichannel version.
Sensopress LCD is a device which allows to start a relay ( 4 relays in the multichannel version) in
function of differential threshold levels set-up in the data storage by the user.
Thanks to its LCD display in which they are visualised all the information concerning the device
and to the three function keys with which it is possible to interact so that to change the parameters,
Sensopress LCD can be easily used.
Sensopress LCD in the multichannel version, by using just a sensor, allows to supervise the start of
4 relays in function of 4 different differential threshold set-up by the user.
• Room-temperature: between +5°C and +40°C
• Maximum relative Humidity: 50% to +40°C (no condensation)
• Sensopress LCD must be installed in locations protected from bad weather and frost.
• The Sensopress LCD sensor can be used in waters free of chemically aggressive substances
(ph 5÷9)
• Sensopress LCD sensor cannot be used with abrasive liquids, solid fibrous substances,
flammable explosive or aggressive liquids.
exact model number parts to our sales and assistance service when asking
2.1
Product description
2.2
Advantages and Benefits
2.3
Operating Conditions
Sensopress_LCD_Rev_00_Eng.doc Eng
4
Advertisement
Table of Contents
