Channel Mode - MAC3 Sensopress LCD User Manual

This mode is possible only with the multi-channel version and it is used for :
To enable or not the wanted channel.
•
o
Choose the channel to modify the intervention thresholds.
•
Choose the channel to visualise when in the AUTO mode.
•
It is possible to enter the CHANNEL mode from any other mode, by choosing the sign GO to
CHANNEL with the Menu button and by pushing Yes/+.
To enable/disable the channel:
Choose the channel by pushing the button Yes/+, the chosen channel is indicated on the
•
low left side of the display as shown in Figure 6.
Push the button No/- to enable/disable the indicated channel. The indication of the channel's
•
state is visualized on the low right side of the display as shown in Figure 6.
In particular:
•
o
o
The channel that stays chosen on the display, no matter if active or not, is the one visualised in the
AUTO mode and it is the one on which it is possible to change the thresholds in LOW and HIGH
mode.
Current mode
Chosen channel.
Push the button Yes/+
to change channel
Figure 6
4.3.1
!Attention: if the channel is disabled, the corresponding relay, even if the liquid's
level oversteps the set-up thresholds for that channel, does not get active.
ACTIVE = enabled channel
INACTIVE = disabled channel
Channel's state:
ACTIVE:
thresholds.
INACTIVE: the relay does not commute even if the threshold
overstep.
To enable/disable the channel push button No/-

CHANNEL Mode

the relay commutes in function of the set-up
Sensopress_LCD_Rev_00_Eng.doc Eng
12