Setting Menu - MAC3 Sensopress LCD User Manual

Current mode
Figure 5
The auto mode is the default one, and if the device is in a different mode, after some minutes of
inactivity it goes on the AUTO mode.
After the choise of the wanted mode with the Menu button, push button Yes/+ to enter it.
By pushing the Menu button it is possible to choose between the different modes of visualising and to
set-up the device.
in particular there are the following modes:
Mode Accomplished Operation
AUTO Indicates :
CHANNEL Only with the multi-channel version
LOW Set-up of the low threshold for the chosen channel
HIGH Set-up of the high threshold for the chosen channel
MANUAL Manual set-up of the outputs
DISPLAY Display's backlight adjustment
PROTECT Insertion of the device's protection
CALIB Fine-tune the water's level scale
4.3

Setting menu

The water's level in the tank
•
The chosen channel
•
The low and the high threshold set-up for the chosen channel
•
The relay's state of the chosen channel
•
Channel selection both for visualization in AUTO and for the set-up of the
•
intervention's threshold in LOW and HIGH.
Enabling and disabling of the channels
•
Sensopress_LCD_Rev_00_Eng.doc Eng
Changing mode
request
11