Manual Mode - MAC3 Sensopress LCD User Manual

Sensopress_LCD_Rev_00_Eng.doc Eng
LEVEL: 301 cm in Figure 8). By pushing the Yes/+, No/- buttons it is possible to increase or to
decrease the wanted maximum threshold; the maximum threshold cannot be lower than the minimum
one; if this gets reached the device will start again from the point 899 cm; with the Menu button it is
possible to memorize the set-up value and it is possible to go to the changing state request; if no
button is pushed the device goes to the AUTO state.
Low threshold currently set-up for
the chosen channel
Chosen channel
In the single
output version
it is shown
HIGH
High threshold possible to set-up,
for the chosen channel, with the
Figure 8
Yes/+ e No/- buttons
To set-up the high threshold of a channel which is not the chosen one it is necessary to go to the
CHANNEL mode and choose the wanted channel by following the instructions described in paragraph
4.3.1 CHANNEL Mode
4.3.4

MANUAL Mode

The MANUAL Mode is necessary to activate or disactivate manually the relays of the different
channels.
It is possible to enter the MANUAL Mode from any other mode by selecting the sign GO to MANUAL
with the Menu button and by pushing Yes/+.
On the display it is shown the state name (Manual) and the relay position (Relay: OFF, Relay: ON)
and the number of the channel correspondent to the relay. (in the single output version there is no
channel indication)
In the MANUAL state , by pushing button Yes/+, it is possible to intervene on the relay, so that to pass
from ON to OFF
Button No/- is used to select the channel on which one wants to intervene manually.
The activating of the relay in the MANUAL mode is not linked to the channel state. It can be enabled
or disabled.
With the Menu button it passes to the state of chaning request.
NOTE
!Attention: in the MANUAL state the device does not go back automatically to the AUTO state!
If needed to leave the MANUAL state use the Menu button as usual.
14