Calib Mode; Zero Calibration - MAC3 Sensopress LCD User Manual

Sensopress_LCD_Rev_00_Eng.doc Eng
5.1

CALIB Mode

It is possible to enter the CALIB mode from any other mode by selecting the sign GO to CALIB with
the Menu button and by pushing Yes/+.
In the CALIB mode it is possible to save the reading realized by the sensor that has been put through
level zero and through the maximum level that can be fit by the user.
This makes the reading correct in all the expected measure field.
When entered this, there is the visualization of Figure 14.
By pushing the No/- button it is possible to enter the procedure of zero setting.
By pushing the Yes/+ button it is possible to enter on the procedure of the setting of the maximum
level.
Push button Yes/+ to calibrtae the high level.
Figure 14
Push button No/– to calibrate the zero.
5.1.1

Zero Calibration

It is possible to enter the zero calibration by pushing the No/- button after entered the CALIB.
On the display it is visualised the screen of Figure 15.
Figure 15
Make sure the sensor is at zero level.
Push the Menu button to enter the zero setting and it is visualized the screen of Figure 16.
17