New Elsa Error Codes; Capi 2.0 Error Messages - ELSA MicroLink ISDN/PCC-16 User Manual

Isdn adapter board
Table of Contents

Advertisement

CAPI error code Meaning
400Ch
Error in document transfer; wrong data sent Your fax software sends wrong data to the

New ELSA Error Codes

CAPI error code Meaning
Requested operating mode not supported
31FFh
No further connection possible for this
application
32Feh
No further B channel layer 3 connection
available
32FFh
No further B channel available
NOTE

CAPI 2.0 Error Messages

CAPI
Meaning
error
code
CAPI REGISTER Error Codes
1001h Too many applications
1002h Logical block size too small (minimum 128 bytes)
1003h Buffer exceeded 64 kb
1004h Message buffer too small minimum 1024 Bytes)
1005h Maximum number of logical connections not
supported
1006h reserved
1007h The message could not be accepted because of an
internal overload
1008h Problem with the computer's resources (e.g. too little
memory)
1109h CAPI not installed
MicroLink ISDN/PCC-16 Manual © 1997 ELSA GmbH
Error codes not listed here are errors between the application and the CAPI
interface. Please refer to the manual for this application or contact the
manufacturer.
Appendix: CAPI Error Codes
Reason and possible solution
adapter board. Contact the manufacturer of
your software or your dealer
Reason and possible solution
Resource problems, probably too many CAPI
applications loaded simultaneously
Reason and possible solution
Close other applications
Configure your applications for a maximum
of two connections, if applicable
Repeat the call
Close other applications
Install CAPI
31

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MicroLink ISDN/PCC-16 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents