3.3 Installation Under Windows 95 - ELSA MicroLink ISDN/PCC-16 User Manual

3.3 Installation under Windows 95

Requirements
Install Dial-Up
Networking
Install the
Network Adapter
MicroLink ISDN/PCC-16 Manual © 1997 ELSA GmbH
To install the Windows 95 CAPI driver you will require the ELSA MicroLink CD
and your Windows 95 CD.
Before installing the CAPI driver, the Dial-Up Networking in Windows 95 must
be properly installed. Proceed as follows:
1.
Start Windows 95 and double-click the symbols in the following series:
My Computer, Control Panel, Add/Remove Programs and
Windows Setup.
2. Select the component Communications .
3.
Select Details and highlight the Dial-Up Networking component.
Confirm with OK .
4. From the Control Panel , double-click on the Network icon. If there is
no Dial-Up Adapter present, then select Add... , Adapter , Add... . Now
select Microsoft from the Manufacturer dialog, select the Network
Adapter, and click on OK .
The Dial-Up Networking should now be properly installed and ready for
operation. In case you require further help, please refer to the Windows 95
documentation.
The installation of the ISDN CAPI 2.0 drivers under Windows 95 is performed
via the CAPI Subsystem which is supplied on your ELSA MicroLink CD. You
should also have your Windows 95 diskettes or CD ready. The installation is
described as follows:
1. Insert your ELSA MicroLink CD into your CD-ROM drive (e.g. drive d: )
2. In Windows 95, double-click on the symbols My Computer, Control
Panel , and Network . The Network dialog will be opened; click
on Add :
ISDN Driver Installation
11