Instructions For Your First Isdn Connection Under Dos - ELSA MicroLink ISDN/PCC-16 User Manual

Operation in AT Mode
4.2.2

Instructions for Your First ISDN Connection under DOS

To establish a test connection, for example to our Support BBS ELSA ONLINE , please proceed as
follows:
Start the CAPI driver DSS1CAPX.EXE (for Euro-ISDN), US__CAPX.EXE (for US protocols) or
n
ISDNCAPX.EXE (for 1TR6).
Start the FOSSIL driver cFos by calling STARTCFOS.BAT or by entering cfos i.
n
Start Telix and enable the INT14 mode. The COM port must be set to COM 2 . This port is the
n
default link to the FOSSIL driver via the interrupt 14h (if you have started cFos with a different
port setting, you must set this port in Telix as well). In INT14 mode the COM ports are not
related to physical serial interfaces, therefore you need not set any bit rate or data format. In
ISDN operation, Telix always uses the highest possible bit rate.
To establish the connection, type ATD 0241 9177 7800 (from within Germany, otherwise enter
n
your international access code (+49) and omit the first 0 ) in terminal mode and press <CR>. Telix
will establish an ISDN connection with the Support BBS ELSA ONLINE . You can terminate the
connection at any time with the Telix command <Alt><H>.
20
MicroLink ISDN/PCC-16 Manual © 1997 ELSA GmbH