ELSA MicroLink ISDN/PCC-16 User Manual page 30

Appendix: CAPI Error Codes
CAPI error code Meaning
34A1h Remote side busy
34A5h Semi-permanent connection not allowed
between these stations
34B5h Wrong remote number, service or service
attribute
34B8h Remote number has changed
34B9h Remote terminal device not ready
34Bah No remote device has answered the call
34BBh Remote terminal device busy
34BDh Incoming calls locked on the remote side
34Beh Call refused by remote side
34D9h Network busy
34Dah Call refused or disconnected by the remote
side
34F0h Local protocol error
34F1h Remote protocol error
Fax operation
4001h Connection could not be established; no fax
device detected on the remote side
4002h Connection cannot be established; local fax
module busy
4003h Line distortion during document transfer,
remote side has refused the transfer due to
poor line quality
4004h Document transfer not possible due to line
distortion
4005h Error in document monitoring; data sent too
slowly to fax module
4006h Fax module locked; too many failed
attempts
4007h Document transfer aborted on local side,
canceled by user or software
4008h Disconnection due to misbehavior of the
remote side; command repetition failed
4009h Explicit logical disconnection by the remote
side
400Ah Unexpected disconnection during document
receiving, line disconnected
400Bh Transfer mode not supported by the remote
side (e.g. file transfer or high resolution)
30
Reason and possible solution
Try to call again later
Apply to your network operator for semi-
permanent connections
Check the remote number and the
availability of the desired services (this
applies also to private branch exchanges)
Ask for the new number of the remote side
Check whether the remote side is ready for
operation
Check whether the remote side is ready for
operation and the remote EAZ or MSN used
Try to call again later
Ask the remote side to accept incoming calls
Contact the remote side
Try to call again later
Try to call again later or contact the remote
side
Try to call again and check the CAPI driver
Check the remote number or contact the
remote side
Wait until the current fax/modem connection
is finished
Try to call again
Try to call again
Select a lower transfer speed for fax
operation or close other active applications
Try to call again later
Check why the fax software has aborted the
connection
Try to call again
Contact the remote side
Try to call again
Check the operating mode and resolution
setting of your fax software
MicroLink ISDN/PCC-16 Manual © 1997 ELSA GmbH