Suzuki GRAND VITARA 2005 Manual page 17

Continuity Check
1) Measure resistance between connector terminals at
both ends of the circuit being checked (between "A-
1" and "C-1" in the figure). If no continuity is indicated
(infinity or over limit), that means that the circuit is
open between terminals "A-1" and "C-1".
2) Disconnect the connector included in the circuit
(connector-B in the figure) and measure resistance
between terminals "A-1" and "B-1".
If no continuity is indicated, that means that the
circuit is open between terminals "A-1" and "B-1". If
continuity is indicated, there is an open circuit
between terminals "B-1" and "C-1" or an abnormality
in connector-B.
Voltage Check
If voltage is supplied to the circuit being checked, voltage
check can be used as circuit check.
1) With all connectors connected and voltage applied to
the circuit being checked, measure voltage between
each terminal and body ground.
a) If measurements were taken as shown in the
figure and results were as listed in the following,
it means that the circuit is open between
terminals "B-1" and "A-1".
Voltage between each terminal and body
ground
"C-1" and body ground: Approx. 5 V
"B-1" and body ground: Approx. 5 V
"A-1" and body ground: 0 V
b) Also, if measured values were as listed in the
following, it means that there is a resistance
I2RH01010052-01
(abnormality) of such level that corresponds to
the voltage drop in the circuit between terminals
"A-1" and "B-1".
Voltage between
"C-1" and body ground: Approx. 5 V
"B-1" and body ground: Approx. 5 V
"A-1" and body ground: Approx. 3 V
"A-1" and "B-1": 2V voltage drop
I2RH01010053-01
Precautions: 00-14
I5RH01000005-01