Install The Phm - Supermicro SuperServer 620P-TR User Manual

Install the PHM

After assembling the Processor Heatsink Module (PHM), you are ready to install it into the
CPU socket.
1. Locate four threaded fasteners (a, b, c, d) on the CPU socket.
b
d
(a, b, c, d: Threaded Fasteners)
2. Locate four peek nuts (A, B, C, D) and four rotating wires (1, 2, 3, 4) on the heatsink as
shown below.
A, B, C, D: Peek Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Rotating Wire
Peek Nut
(Unlatched)
3. Check the rotating wires (1, 2, 3, 4) to make sure that they are in the unlatched position
as shown.
Chapter 3: Maintenance and Component Installation
CPU Socket
c
a
Rotating Wire 4
D
d
(latched)
CPU Socket
34
Threaded Fastener
CPU Socket Pin1
Heatsink
B
2
Rotating Wire
C
Rotating Wire
A
Peek Nut
b
c
a
Threaded Fastener
3
1