Download Print this page

Operation - Sharp FP-JC2 Operation Manual

Hide thumbs

Advertisement

OPERATION

Selecting Mode  
「TURBO」 運転
While the operation is stopped
• The "TURBO" is enabled by just pressing the
Turbo Button. When the "TURBO" is executed
by pressing the button, the operation is
stopped by pressing the Turbo Button or
Operation Button and returns to "AUTO".
Light Control
Select the desired brightness.
Even when the power is OFF, the airflow lamp is lit on the "dark" setting and
does not turn off.
(With the unit ON)
Engine synchronizing function
If the vehicle's engine is turned off and the vehicle is stopped while the unit
is operating, the unit resumes operating in the same mode when the vehicle's
engine is started back up.
• For preventing you from forgetting to turn OFF the product, it automatically stops after 4
hours from the operation is started, however, if the main unit is operated even if the key
of the vehicle is pulled out or the engine switch is turned OFF, pull out the cigar plug for
preventing the dead battery.
• It is not a failure should the fan operate with a delay of about 3 to 10 seconds after starting.
FP-JC2.indd
14
AUTO
AUTO ......The fan speed is automatically
controlled depending on air
condition.
When you want to reduce the odor quickly
About twice Plasmacluster ion of "MED" fan speed is
discharge with stronger air volume for 30 minutes.
In operation
• If you press the Turbo Button
Brighter
E-14
MED
OFF
LOW
or Button during the "TURBO"
operation, the mode returns to
the operation mode immediately
before the "TURBO".
Turn OFF
Darker
2018/06/28
11:35:49

Advertisement

loading