Taylor 432 Original Operating Instructions page 32

PROBLEM
4. Product too thick.
5. Product too thin.
6. Scored walls of freezing
cylinder.
7. Excessive leakage into
rear drip pan.
8. Excessive leakage from
door spout.
9. Unable to remove drive
shaft.
Troubleshooting Guide
PROBABLE CAUSE
a. Inadequate mix in hopper.
b. Improper mixing of
product.
c. The viscosity adjustment
is set incorrectly.
d. The torque arm is not
installed.
a. Missing, incorrectly
installed, or bad scraper
blade.
b. Improper mixing of
product.
c. The viscosity adjustment
is set incorrectly.
d. Dirty condensers.
e. Incorrect beater rotation.
(Rotation must be
clockwise.)
a. Broken pin on beater
assembly.
b. Front bearing worn or
missing.
a. Improper or inadequate
lubrication of drive shaft
seal.
b. Bad or missing seal on
drive shaft.
c. Worn rear shell bearing.
a. Improper or inadequate
lubrication of draw valve
o-rings.
b. Bad or missing o-rings on
draw valve.
a. Lubrication on square end
of drive shaft.
b. Rounded corners of drive
shaft, drive coupling, or
both.
28
REMEDY
a. Fill hopper with mix.
b. Carefully follow directions
for mixing product.
c. Adjust the viscosity
control.
d. Install the torque arm.
a. Install or replace scraper
blade.
b. Carefully follow directions
for mixing product.
c. Adjust accordingly.
d. Clean regularly.
e. Contact an authorized
service technician.
a. Repair or replace beater
assembly.
b. Replace or install front
bearing.
a. Use correct lubricant
(Taylor Lube) and follow
lubrication procedures.
b. Replace seal every 3
months.
c. Contact an authorized
service technician.
a. Use correct lubricant
(Taylor Lube) and follow
lubrication procedures.
b. Replace o-rings every 3
months.
a. Do not lubricate the
square end. Contact an
authorized service
technician.
b. Contact an authorized
service technician.
Model 432 Tim Hortons
PAGE
REF.
21
- - -
13
19
16
- - -
13
25
- - -
- - -
16
15
29
- - -
15
29
15
- - -