Taylor 432 Original Operating Instructions page 20

Step 2
Insert the beater drive shaft into the rear shell
bearing and engage the square end firmly into the
female socket of the drive unit. Be certain that the
drive shaft fits into the drive coupling without
binding.
Figure 7
Step 3
Check the scraper blade for any nicks or signs of
wear. If any nicks are present, replace the blade. If
the blade is in good condition, install it on the beater
assembly. Be sure the holes in the blade are
securely positioned over the beater pin.
Figure 8
131009
Operating Procedures
Step 4
Holding the beater securely, slide the beater into the
freezing cylinder and align the hole at the rear of the
beater with the flats on the end of the drive shaft.
Slide the beater the remainder of the way into the
freezing cylinder and over the end of the drive shaft.
The beater assembly should not protrude beyond
the front of the freezing cylinder.
Step 5
Install the white plastic guide bearing on the short
end of the torque rotor. Slide the o-ring into the
groove on the long end of the torque rotor and
lubricate the o-ring. Do not lubricate the guide
bearing.
16
Figure 9
Figure 10
Model 432 Tim Hortons