Cold pull method
Problem: One of the extruders is making a clicking noise or not pushing out the
filament?
Cause: It's most likely clogged or partially clogged. Follow this guide to use the cold pull
method to fix the extruder or just to clean it., This is also recommended when switching
materials.
Setting the temperature
First we need to set the temperature of the extruder to the of the material that's
currently in it, for this example we are going to use PLA temps or 195°C (383°F) in this
case, for PETG and ABS you might want to go a little higher like 220°C (428° F).
Navigate to the change filament menu.
Set the temperature to the material that's in the head, so 195°C (383°F) for PLA in this
case, also select the extruder that has the jam