Important Display Messages - Hoffrichter point 2 User Manual

Important display messages

The most important display messages are listed below. All further messages will be
clarified from the given context.
 
The values shown here are examples.
  
 
  
 
 
  
 
 
 
 
  
 
  
 
  
 
  
@ ;$
$ *#! %(/!.
68 Operating the Device
You still have 15 seconds to ensure that the mask is
fitted correctly. When the time is up, the device starts
the soft start function or the therapy.
There are still 8 minutes and 40 seconds until full the-
rapy pressure is reached.

You have activated the display of the tidal volume as
well as the wake up alarm.
The mask has slipped off your face or a leak that cannot
be compensated for has occurred or you have not put
the mask on in the „Auto OFF" or „Auto Start" auto-
matic modes while the blower is running.

In normal mode you have pressed the selection key
and get the message that you will be woken up at 7 a.m.
In normal mode you have pressed the selection key
and get the message that the alarm clock has now
been switched off.
The wake alarm has been triggered. Press the ON/OFF
key once to initiate the slumber phase. Press the key
once again to turn off the alarm completely.
You still have 1 min and 18 s until the alarm clock will
sound again.
You have pressed the ON/OFF key and ended the slum-
ber phase.
The filter must be changed (see page 81). To reset
the message, hold the enter key
you are doing this, insert the DC power supply plug
into the device's DC power connection.
down and, while