Soft Labels; Softkeys - Fluke 96000 Series Operator's Manual

Soft Labels

Six soft labels run vertically along the right side of the screen and five run
horizontally along the bottom of the screen. Each of the labels corresponds to an
adjacent softkey. When a soft label contains text, push its adjacent softkey to
direct the display to respond accordingly.
The horizontal soft labels across the bottom of the screen provide prompts to
expand the current definition, add/remove fields, or call another screen (menu
selection).
Push  while in either of two field edit modes (cursor or step edit) to cause
the soft labels to present a selection of measurement units for use with the
selected field. During alphanumeric (keypad) edit, the soft labels present a
selection of scientific multipliers for use with the selected field. These multipliers
are shown in terms of the previously selected units (watts, dBm, volts).
If a soft label contains no text, pushing its adjacent softkey has no effect.
However, when a labeled softkey is pushed the effect is immediate and obvious
on the display.

Softkeys

The Instrument has two sets of softkeys. One vertical set running down the right
side of the display and one horizontal set running across the bottom of the
display. Each of these softkeys has an adjacent soft label on the screen.
The primary function of the vertical softkeys is for selection of the focus field, and
in some cases the edit mode (Cursor edit or Step edit) for the focus field. These
keys are also used to temporarily present scientific multipliers during
alphanumeric entry with the keypad and unit selections, if  is pushed.
The horizontal softkeys are associated with the soft labels across the bottom of
the display. These labels provide prompts to expand the current definition,
add/remove fields, or call another screen (menu selection).
Local Operation
Controls, Indicators, and Connectors
3
3-11