Page 3
At iSpring, we strive to develop products to the highest standards and make excellent drinking water accessible for all households. With affordable pricing, reliable quality, prompt delivery, and top-notch customer service, we hope to assist in bringing you great water for years to come.
Spare Clips Product Overview The iSpring Ultraviolet Water Filter (Model: UVF11A/UVF11B/UVF11B-A/UVF11B-E) is an innovative way to purify water and is suitable for residential use. The UVF11 series are designed for easy installation. It is also designed to operate with a minimal amount of maintenance.
The UVF11 series come with a flow sensor that turns the UV on and off automatically with water flow. It automatically turns off when the flow sensor detects there is no water flowing through the unit. This special design reduces energy consumption and prolongs the life span of the UV lamp.
The UVF11 series are NOT intended to treat water with obvious contamination or intentional source, such as raw sewage; nor is the unit intended to convert wastewater to safe drinking water. Precautions Warning: - Changes or modifications made to this system without the manufacturer's consent could render the system unsafe for operation and may void the manufacturer's warranty.
Page 8
Step 2. Install one of the O-rings onto the open end of the quartz tube (about 5 mm from the opening). Step 3. Insert the quartz tube into the reactor chamber. Step 4. Install the other O-ring onto the closed end of the quartz tube. Step 5.
Page 9
Step 6. Insert the two pins of one end of the UV lamp into the female end of the blue cable. Step 7. Carefully insert the UV lamp and the blue cable into the quartz tube. Hand-tighten the open end nut onto the reactor chamber. Step 8.
Page 10
Step 10. Carefully insert the UV lamp and the blue cable all the way down into the reactor chamber. Install the black cover cap attached to the ballast onto the open end nut. Step 11. Install the elbow fittings onto the water inlet and outlet of the reactor chamber: 1) remove one clip from each of the fittings;...
Page 11
Step 14. Install the two supporting pieces when needed. Place the UVF11 unit in a proper location. Note: Cut the 1/4'' tubing (not included) using a sharp blade to an appropriate length to avoid kinking. Ensure the tubing is fully inserted into the quick-fitting connection about half an inch deep and secure the connection with the supplied blue clips.
Maintenance and Inspection For your safety, always wear eyewear and turn the power off before servicing the unit. Servicing the unit with the power on will also cause damage to the ballast. A. Clean the UV Lamp and the Quartz Tube Clean the UV lamp and quartz tube at least three times a year if the unit can be dismounted easily.
Troubleshooting Problem Solution After turning on the water supply, the 1. Ensure that the water flow switch is correctly ballast does not turn on automatically. connected. Verify that the direction of the water flow on the water flow switch is correct. 2.
Warranty Registration To register your product for the warranty, visit our website at 123filter.com and go to the "Warranty" tab. We provide a 30-day money-back guarantee, a 1-year manufacturer warranty, and lifetime tech support for all of our products. However, we do not have the order information from websites other than 123Filter.com (Amazon, Home Depot, etc.), so please fill in that information upon registration of your system.
Page 16
Atlanta, GA USA iSpringFilter.com For questions, comments, or technical support, contact us at: support@123Filter.com (678) 261-7611 Monday-Friday 8:30 a.m. - 5:30 p.m. EST www.123filter.com | (678) 261-7611 | support@123filter.comPage 16...