Dakota Digital BIM-01-2 Quick Start Manual page 9

BIM setup continued:
Enable or disable gear position output from the BIM-01-2
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows "" (gear position). Press and hold to enter this menu.
•
When you see "" on the display release the switch.
•
The display will show the current state of the gear position  * (enable) or  (disable).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see "" on the display, then release the switch.
• The display will show "". Press and hold the switch to exit setup or tap to choose another menu option.
Enable or disable vacuum/boost output from the BIM-01-2
**Note: This reading is taken from the MAP sensor. A functional MAP sensor is required for an accurate reading. Vacuum
reading is in inHg and boost is in PSI.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows "" (boost). Press and hold to enter this menu.
•
When you see "" on the display release the switch.
•
The display will show the current state for boost enable  * (enable) or  (disable).
•
If turningensure the BIM is connected to a VHX/HDX/VFD3/RTX system because the BIM will automatically
choose a BIM channel on the system.
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see "" on the display, then release the switch.
• The display will show "". Press and hold the switch to exit setup or tap to choose another menu option.
Enable RPM signal for Ford Performance control pack/Coyote Engines
**Note: It is recommended to use the default setting (). Only enable this setting if your RPM signal is not functioning.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows "" (TACH). Press and hold to enter this menu.
•
When you see "" on the display release the switch.
•
The display will show the current state  (standard) or  (Ford).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see "" on the display, then release the switch.
• The display will show "". Press and hold the switch to exit setup or tap to choose another menu option.
Enable Speed signal for Ford Performance control pack/Coyote Engines
**Note: It is recommended to use the default setting (). Only enable this setting if your Speed signal is not functioning.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows "" (SPEED). Press and hold to enter this menu.
•
When you see "" on the display, release the switch.
•
The display will show the current state  (standard) or  (Ford).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see "" on the display then release the switch.
• The display will show "". Press and hold the switch to exit setup or tap to choose another menu option.
[9] MAN #650500G