VFD3 Setup Continued:
Obtaining oil pressure from the BIM-01-2 (if available)
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display should show and the message display should show SETUP.
o
•
Release SW1. Tap SW1 until and OIL are displayed.
•
Press and hold SW1 for at least 3 seconds, until changes to "-". The displays should show and SENDER.
•
Press and hold SW1 for at least 3 seconds, until changes to "-". The speed display will show the current
setting.
•
Tap SW1 until and BUS are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
•
Tap SW1 until and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
[4]
MAN #650500G