Dakota Digital BIM-01-2 Quick Start Manual page 3

VFD3 / VFD3X Setup:
Entering the VFD3 setup is done by holding SW1 (I) and turning the ignition to "on", or "acc".
Once in setup, one can move between speed, tach, volt, water, etc.... by tapping SW1 (I)
If you are setting multiple items, once done with one section you will automatically move onto the next item.
Obtaining speed from the BIM-01-2
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display will show  and the message display will show SETUP.
o
•
Release SW1. The displays should show and SPEED, respectively.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The message display will show SENDER.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The speed display will show the current
setting.
•
Tap SW1 until  and BUS are displayed.
•
Press and hold SW1 until  and DONE are displayed.
o
NOTE: The AUTO, auto calibration, is removed.
o
Speed can only be fine-tuned with the ADJUST mode at a standstill.
o ADJUST now only alters the percentage of speed by +/- 25%.
▪
▪
▪
▪
•
Tap SW1 until  and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are display.
Obtaining RPM from the BIM-01-2
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display should show  and the message display should show SETUP.
o
•
Release SW1. Tap SW1 until  and TACH are displayed.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The displays should show  and T CAL.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The speed display will show the current
setting.
•
Tap SW1 until and BUS are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
•
Tap SW1 until  and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
Obtaining engine temperature from the BIM-01-2
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display should show  and the message display should show SETUP.
o
•
Release SW1. Tap SW1 until  and WATER are displayed.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The displays should show  and SENDER.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The speed display will show the current
setting.
•
Tap SW1 until  and BUS F (Fahrenheit) is displayed.
Tap SW1 once more for  and BUS C (Celsius) if desired.
o
•
Press and hold SW1 until "-" and DONE are displayed.
•
Tap SW1 until  and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
Drive a known speed and calculate how far off the speed is in percentage.
•
GPS speed / displayed speed x 100
•
Sample - [60/50=1.2] [1.2x100 = 120] 120%
Enter setup and go to ADJUST, tap SW1 to increment from 100% up to 125%.
After 125% the values will fall back to 75% and increment up again.
When the desired percentage is reached, hold SW1 until  changes to "-".
[3] MAN #650500G