Dakota Digital BIM-01-2 Quick Start Manual page 6

VHX Setup Continued:
Obtaining oil pressure from the BIM-01-2 (if available)
•
Hold the SW1 (I) switch from the instrument system control box while turning the key on.
o
The message display should show SETUP.
•
Release SW1 (I) - LCD1 should show SETUP SPEED.
•
Tap SW1 until SETUP OIL is displayed.
•
Press and hold SW1 (I) for at least 3 seconds until OIL SENDER is displayed.
•
Press and hold SW1 (I) for at least 3 seconds until SENDER NORMAL is displayed.
•
Release the switch and SENDER NORMAL will be displayed.
•
Tap SW1 (I) until SENDER BUS is displayed.
•
Press and hold SW1 (I) until DONE is displayed.
•
Tap SW1 (I) until OIL DONE is displayed.
•
Press and hold SW1 (I) until a big DONE is displayed.
[6] MAN #650500G