Advertisement
Quick tips:
While the BIM is operating, the dot in the upper left corner of the display will indicate the status:
•
On steady indicates it is powered up but not receiving any BIM bus activity.
•
Flashing indicates it is communicating on the BIM bus.
•
A dot in the upper center indicates that there is an engine code set (MIL active).
•
If the display is sequencing through "", "", "", then it is scanning to try and communicate with the vehicle
bus but cannot get an answer.
o
This could indicate that the ODBII connector is not wired properly
o
The BIM-01-2 is not compatible with following the ECU types
▪
▪
▪
▪
To see the sensor and channel status on the BIM display, press and hold the switch to cycle through the screens.
The first items to show is the protocol letter with a number "" (Ford), "" (GM/Chrysler J-1850), or "" (CAN).
If the first thing displayed is "", the BIM-01-2 is reading CAN, and three extra readings.
Speed, RPMs, and engine temp are expected, everything else is an extra.
The next screens will indicate which data is available:
"" - Engine Oil Pressure
"" - Transmission Fluid Temp
"" - Ambient Air Temp
"" - Intake Air Temp
"" - Gear Position
"" - Fuel Level Input
"" - Boost/Vacuum data
"" - Speed data
"" - RPM/Tachometer data
"" - Engine Coolant Temp
If you do not see any number of these listed it means it may not be transmitted for the BIM-01-2 to read.
Emissions note:
If your vehicle requires emissions testing in your area, the check engine feature of this unit cannot be used to operate the
Check Engine or Service Engine indicator.
Troubleshooting guide:
Problem
No BIM data on instrument readout;
BIM does not light up.
No BIM data on instrument readout;
BIM display is scanning "J", "F", "C"
No BIM data on instrument readout;
BIM has a steady dot lit.
BIM display shows ":"
European or Asian protocols
Non SAE standard (US) CAN bus
Pre OBDII years
Chrysler ECUs older than 2004
Possible cause
PWR wire does not have power.
GND wire is not properly grounded.
Power/data harness is damaged.
Module is damaged.
OBD-II Interface cable is not connected.
The vehicle bus is not compatible.
The bus ID is not compatible.
Interface cable is not connected.
Interface cable is loose.
On VHX systems, the BIM display for
this channel is disabled.
Data cable is damaged or connected
improperly.
Another module on the bus is damaged.
Connect to a location that has +12V key-on power.
Connect to a different ground location.
Inspect harness. Repair or replace any damaged
areas.
Return for service. (see instructions)
Connect the supplied OBD-II cable between the
BIM unit and the vehicle diagnostic plug.
Vehicles using the ISO 9141-2 protocol are not
compatible with the BIM-01-2.
Some vehicles require the bus ID to be changed to
, or.
Connect the supplied harness between the BIM
unit and the instrument system control box.
Ensure both ends of the cable are seated securely.
Follow instructions in VHX manual to enable the
BIM display screen.
Inspect and replace harness or power/data
harness.
Inspect other modules on the data bus.
[10]
Solution
MAN #650500G
Advertisement
