Dakota Digital BIM-01-2-FAST Manual

Connect to the BIM-01-2
if you need to connect to a
BIM-xx-2
This Bus Interface Module is designed to read engine information from FAST XFI and TCI EZ-TCU kits. FAST EZ-EFI kits
are not compatible. This module is connected to the FAST/TCI kits through the included Y-adapter harness. This can be
plugged in line with the dedicated CAN terminals on the EFI/TCU harness.
There are two interface (I/O) ports on the module. Either one can be connected to the gauge system or to another
module, allowing several units to be daisy chained together. Do not connect the I/O port to anything other than a Dakota
Digital gauge or BIM. Do not mount the module in the engine compartment; it should be mounted in interior of the vehicle.
The engine and transmission information that is available from the unit depends on the EFI module programming and
add-ons. The possible values are: engine RPM, engine coolant temperature, current gear, oil pressure, fuel pressure,
average A/F ratio.
Data that should always be available: RPM, engine temp, fuel pressure, A/F ratio, Oil pressure
Data that is add-on dependent: Current gear, MPH, Intake air temp
Bus Interface Module for FAST EFI
BIM-xx-2 power & data connectors.
Either one can be used.
www.dakotadigital.com
techsupport@dakotadigital.com
BIM-01-2-FAST
Bridge Module for FAST EFI Systems
INPUT
FAST EFI-Y-adapter harness
Connect in-line FAST EFI
BIM-xx-2 18 inch power/data harness
BIM-01-2-FAST
605-332-6513
setup/status switch
Connect to the BIM-01-2
Connect directly to
another BIM-xx-2
MAN #650587A