Appendix; Technical Data; Approvals; Fcc: Federal Communications Commission Radio Frequency Interference Statement - Beckhoff C9900-P223 Installation And Operating Instructions Manual

Appendix

Electrical data
Dimensions
Do not use the power
supply unit in areas of
explosive hazard
Environmental conditions
Shock resistance
EMC compatibility
Transport and storage
FCC Approval for USA
FCC Approval for Canada
C9900-P223 / C9900-P224
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from

Technical data

Input voltage:
Power output:
Output voltages:
Dimensions (W x H x D):
Weight:
The power supply unit must not be used where there is a risk of
explosion.
The following conditions must be observed during operation:
Ambient temperature:
Atmospheric humidity:
Sinusoidal vibration
(EN 60068-2-6):
Impact
(EN 60068-2-27/ -29):
Resistance to interference: according to EN 61000-6-2
Emission of interference:
The same values for atmospheric humidity and shock resistance are to be
observed during transport and storage as in operation. The shock
resistance during transport can be improved by appropriate packaging of
the power supply unit. The ambient temperature during storage and
transport must be between -20°C and +65°C.

Approvals

FCC: Federal Communications Commission
Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.

FCC: Canadian Notice

This equipment does not exceed the Class A limits for radiated emissions
as described in the Radio Interference Regulations of the Canadian
Department of Communications.
22-30V DC/ 15A
max. 150W , depending on cooling
see section Electrical data
50 x 25 x 104 mm
120 g
0 to 55°C
Maximum 95%, non-condensing
10 to 58 Hz: 0.035 mm
58 to 500 Hz: 0.5 G (~ 5 m/ s
5 G (~ 50 m/ s²), duration: 30 ms
according to EN 61000-6-4
Appendix
2
)
15