Fitting The Cable; Material For Assembling The Connectors; Assembling The Connectors - Beckhoff C9900-P223 Installation And Operating Instructions Manual

Installation Instructions
Wiring in accordance with
wiring diagram
Material for assembling the
connectors
Conductive cross-section
Fitting the connector to the
cable
Applying the strain relief
Putting in the plug
connector
Fixing the upper part of the
strain relief housing
12
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from

Fitting the cable

Fit the cables for the power supply of the Industrial PC, the connection of
the battery pack as well as the connection of the power-switch in
accordance with the wiring diagram, using the included material for

assembling the connectors.

Material for assembling the connectors

Assembling the connectors
The connector is specified for 16 A and can lift conductive cross-sections
2
until 1.5 mm .
So the connector is fitted to the cable:
1. Strip insulation from the cable ends (Length of stripped conductor
is 8 – 9 mm).
2. Screw together the cable ends in the 8-pole plug connector in
accordance with wiring diagram.
Plug connector 8-pole, Strain
relief housing with lacing cord
Thread the lacing cord into that
lower part of the strain relief
housing.
Put the plug connector into that
lower part of the strain relief
housing.
Tighten the lacing cord and pinch off
the plastic strap.
Fix the upper part of the strain relief
housing by snapping it onto the
lower part.
C9900-P223 / C9900-P224