Advertisement
YAW SETTING
RUDD light on – click SET – GYRO light flashes
GND 5V S
S-BUS
CH1
CH2
CH3
To adjust flight controller settings, press the SET
key for 3 seconds. Click SET key until RUDD light
is on and GYRO light flashes. When the GYRO
light flashes 5 times it indicates factory default yaw
gain. Move the elevator stick up and down to
increase or decrease the yaw gain setting. The
amount of flashes indicates the level, 1 being the
lowest to 9 being the highest. After the desired
level is achieved, press the SET key for 3 seconds
to save the setting.
5V GND D
DSM/X
SET
BIND
YAW GAIN SETTING
SERVO
PITCH
SPEED
AGILE
GYRO
-3-
RUDD
ELEV
AILE
LED
Advertisement
