Blue Indicator Lights; Onboard Diagnostic System - Obd Ii - Chrysler 300c Owner's Manual

20_LX_OM_ENA_GCC_t.book Page 88
88 GETTING TO KNOW YOUR INSTRUMENT PANEL
LaneSense Indicator Light — If Equipped
When the LaneSense system is ON,
but not armed, the LaneSense indi-
cator light illuminates solid white. This
occurs when only left, right, or neither
lane line has been detected. If a single lane line
is detected, the system is ready to provide only
visual warnings if an unintentional lane depar-
ture occurs on the detected lane line.
Refer to "LaneSense — If Equipped" in "Starting
And Operating" for further information.
Custom Mode Indicator Light
This light will turn on when Custom
Mode is active.
Refer to "SRT Drive Modes" in "Multimedia" for
further information.
Sport Mode Indicator Light
This light will turn on when Sport
Mode is active.
Refer to "SRT Drive Modes" in "Multimedia" for
further information.
Track Mode Indicator Light
This light will turn on when Track
Mode is active.
Refer to "SRT Drive Modes" in "Multimedia" for
further information.
Valet Mode SRT Indicator Light
This light will turn on when Valet Mode
is active.
Refer to "SRT Drive Modes" in "Multimedia" for
further information.
Speed Warning Indicator Light
The indicator light will illuminate white
along with a notification message
(Speed Warning Set to XX followed by
unit). When the set speed is just
exceeded, a single chime will sound along with
pop up message of Speed Warning Exceeded.
When the set speed is exceeded by 2 mph
(3 km/h) or more, the indicator will light up
yellow and flash along with a continuous chime
(up to 10 seconds or until the speed is no longer
exceeded).
NOTE:
The number "31" is only an example of a speed
that can be selected.

Blue Indicator Lights

High Beam Indicator Light
This indicator light will illuminate to
indicate that the high beam head-
lights are on. With the low beams acti-
vated, push the multifunction lever
forward (toward the front of the vehicle) to turn
on the high beams. Pull the multifunction lever
rearward (toward the rear of the vehicle) to turn
off the high beams. If the high beams are off,
pull the lever toward you for a temporary high
beam on, "flash to pass" scenario.
ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated
Onboard Diagnostic system called OBD II. This
system monitors the performance of the emis-
sions, engine, and transmission control
systems. When these systems are operating
properly, your vehicle will provide excellent
performance and fuel economy, as well as
engine emissions well within current govern-
ment regulations.