Advertisement
Available languages
Available languages
Congratulations, you have just purchased a FACNOR furling and reefing system, "the
easiest to install" system available today.
Please take a few minutes to read the following instructions before proceeding, this
furling system has been designed for a simple and quick installation.
Please note that to fit with jib furling system, you need to have a low terminal with Ø
Low terminal with a maximum Ø of 13,6 mm
Ex: manual terminal (norseman, sta-lock.......) or swage rigging screw.
THE FURLING SYSTEM KIT:
st
- 1
parcel:
including
nd
- 2
parcel:
including
You need the following tools to fit your FACNOR system:
I. FITTING RECOMMENDATIONS
- first slacken the backstay to allow for the loosened headstay.
- use a genoa or spinnaker halyard to rig temporary the headstay to support your
mast during the installation.
- take out forestay pin at the deck level.
MAKING CERTAIN THAT THE MAST IS SECURE !!!
a maximum Ø of 16 mm
a maximum Ø de 22,4 mm
SECTIONS
- sections
- connectors
- telescopic section
BOX
- drum
- halyard swivel
- bearings
- screws
- top cap
- halyard deflector wheel + red bearings
- feeder
- shackles + Allen keys
- pin
- a screwdriver or electric screwdriver
- a soft head hammer
R 80 to R 130
R 150 and R 200
R 260 and R 290
10
Advertisement
