Facnor Asym-FX User Instructions

R A C E D E V E L O P E D
F A C N O R A S Y M M E T R I C S P I N N A K E R F U R L E R
A S Y M - F X
w w w . f a c n o r . c o m
A
1
C
2
A
3
B
4
C'
B –
EASY ORIENTATION OF THE FURLING GUIDE
9
C – INSTALLATION ADVICE BEFORE USE
- Protect the sail against UV and sea water;
- Anticipate foredeck handling. Secure yourself to the boat by a tether line;
- Before hoisting check that the asymmetric Spinnaker furler is clear of any other halyards and lines;
- See with your Facnor dealer how to fit, tighten and block the furling line.
For the good functioning of the anti-twist luff rope, furl and unfurl always in the same way (clock wise or
anti-clockwise). You can mark the furling line or use a winch block.
U S E R I N S T R U C T I O N S
T E C
U S E R I N S T R U C T I O N S

USING AND FITTING THE FURLING LINE

The Facnor hook device allows to quickly release the spliced furling line
from the drum. This clever system is mainly fitted with a stainless steel guide
and a rubber ring. With this concept designed by Facnor the furling line can
be left fitted on the deck. Available identically on both Gennaker (FX) and
asymmetric Spinnaker furlers (Asym-FX).
A –
USING AND FITTING THE FURLING LINE
1 - 2 -
Position the continuous furling line round and above the drum. Put the A
part of the furling line between the right hook (C) and slide the line under the
hook on the right hand side.
3 - 4 - Pull the B part of the furling line to progressively introduce the line under-
neath the rubber ring until to reach the left hook.
5 - 6 - Put down the B part of the furling line and slide the B part of the furling
line underneath the left hooks (C').
7 -
The line runs through both guide exits. It is now ready to use.
A
5
B
9 & 10 -
The stainless steel guide can be adjusted in
order to correctly orientate the furling line according to
the chain plate attachment (see installation instructions).
H N O L O G Y
6
C'
UV
A s y m - F X
(FX models)
(see opposite : FX)
:
7
10
F A C N O R F U R L E R
8
1 / 2