GRAPHTEC FC4500 Series User Manual page 5

Safety Precautions
When disconnecting the power cord or an interface
cable, do not pull on the cord/cable.
•
Such acton wll damage the cord/cable, resultng n a fre
hazard or electrcal shock. Be sure to hold the power cord's
plug or the nterface cable's connector.
Prohibited
Do not clean the plotter using a volatile solvent (such
as thinner or benzine).
•
Such acton may mpar ts performance.
Prohibited
Provide sufficient space around the plotter so that
the media does not strike any objects in the plotter'
s vicinity during cutting or plotting.
•
Such contact may cause cuttng or plottng to go out of
algnment.
No touching
When using the cutter pen, take care not to extend
the cutter blade excessively.
•
An excessve blade length wll damage the cuttng mat and
mpar the plotter's cuttng qualty.
v
Safety Precautions
Do not place magnetic cards, diskettes or similar in
the vicinity of the tool carriage.
•
The magnetc force may destroy the data on the magnetc
cards or dskettes.
Do not attempt to lubricate the plotter's
mechanisms.
•
Such acton may cause t to break down.
If water or foreign matter enters inside the plotter,
do not continue using it. Turn off its power and
unplug its power cord from the electrical socket.
•
Use of the plotter n such status may result n electrcal shock
or a fre hazard due to current leakage.
•
Contact your sales representatve or nearest Graphtec vendor
to request repar.
Unplug the power
cord from the socket
Move the tool carriage slowly when moving it
manually in order to load the medium or for other
reasons.
•
Movng t quckly may damage the plotter.
Prohibited
Prohibited