GRAPHTEC FC4500 Series User Manual page 99

5.9 Assigning Tool Numbers
Ths functon enables you to assgn tool holder 1 and tool holder to COND Nos. 1 to 8.
If the application software is used to perform pen exchange operations,"ENABLED" must be selected for the "Tool
Exchange Commands" setting (see Section 5.28,"Special Functions").
[PAUSE] key to select PAUSE mode.
(1) Press the
[NEXT] key repeatedly untl the followng menu s dsplayed.
(2) Press the
FORCE
I/F
TOOL COND AREA OPT
SPEED
(3) Press the [F2] key (TOOL COND) to dsplay the menu shown below.
FORCE
THICK
TOOL No. ADJ.T POS
SPEED
(4) Press the [F2] key (TOOL No.) to dsplay the tool number assgnment settng screen.
<FC4550-50/4500-60>
FORCE
COND No. 12345678
TOOL No. 21111111
SPEED
The upper row of the dsplay represents the cuttng condton COND Nos. Use the [
blnkng cursor underneath the CONDITION No. for whch you wsh to change the current tool assgnment, and then
use the [ ] or [
The factory default settngs are those shown n the above screen.
[ENTER] key to confrm your selectons.
Press the
[PAUSE] key to cancel PAUSE mode.
(5) Press the
These settings are retained in the plotter's internal memory even while the plotter is turned off.
OFFSET
FUNCTION
QUALITY
OFFSET
CUT LINE
QUALITY
OFFSET
QUALITY
] key to toggle the tool number between 1 and 2.
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
<FC4510-60>
FORCE
COND No. 12345678
TOOL No. 11112222
SPEED
OFFSET
QUALITY
] or [ ] key to move the
5-11