GRAPHTEC FC4500 Series User Manual page 100

Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.10 Assigning Perforation Cutting
Ths functon allows you to assgn the perforaton cuttng operaton to COND Nos. 1 to 8.
(1) Press the [PAUSE] key to select PAUSE mode.
[NEXT] key repeatedly untl the followng menu s dsplayed.
(2) Press the
FORCE
I/F
TOOL COND AREA OPT
SPEED
(3) Press the [F2] key (TOOL COND) to dsplay the menu shown below.
FORCE
THICK
TOOL No. ADJ.T POS
SPEED
(4) Press the [F3] key (CUT LINE) to dsplay the perforaton cuttng operaton assgnment settng screen.
FORCE
COND. No. 12345678
CUT LINE
SPEED
Blinking cursor
The upper row of the dsplay represents the cuttng condton COND Nos. A check mark [ ] s dsplayed for any of
the COND. Nos. to whch the perforaton cuttng operaton has been assgned.
Use the [ ] or [
operaton to, and the [
Press the [ENTER] key to confrm your selectons.
(5) Press the [PAUSE] key to cancel PAUSE mode.
•
These settings are retained in the plotter's internal memory even while the plotter is turned off.
•
Please see Section 3.7, "Setting the Cutting Conditions" for details on perforation settings.
5-12
OFFSET
FUNCTION
QUALITY
OFFSET
CUT LINE
QUALITY
OFFSET
QUALITY
] key to move the blnkng cursor to the COND. No. that you want to assgn the perforaton cuttng
] or [ ] key to dsplay or hde the check mark [ ].