Table of Contents
Advertisement
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(3) Wth the plotter n Ready status, press a key from [F1] to [F4] to select the COND No. for the creasng tool test.
Select ether "CP001" as the cutter blade type.
(4) Use the [
] [
startng poston for the cuttng test.
(5) Press the
[TEST] key to dsplay the creasng test selecton screen.
FORCE
TEST1
SAMPLE
SPEED
(6) Press the [F1] key (TEST1) or [F3] key (TEST2) to crease a test pattern.
TEST1: Press the [F1] key to crease a sngle test pattern.
TEST2: Press the [F3] key to crease three test patterns (the frst pattern s creased wth the specfed creasng
force -1, the second pattern s creased wth the specfed creasng force, and the thrd pattern s creased
wth the specfed creasng force +1).
Insufficient creasing force
Increase the creasing force
Check the creasng test patterns. If the pattern s only lghtly creased, the creasng force s nsuffcent. Conversely,
f the pattern s deeply creased or the medum s cut, the creasng force s excessve.
[CONDITIONS] key and adjust your settngs.
(7) Press the
(8) Repeat Steps (4) to (7) untl you acheve the desred results.
(9) When the results are satsfactory, press the
Cutting a sample
Ths test allows you to cut a sample to check the plotter's operaton.
(1) Load a medum for cuttng the sample.
(2) Mount a cutter pen.
(3) Wth the plotter n Ready status, press a key from [F1] to [F4] to select the COND No. for the cuttng test.
(4) Use the [
] [
poston for cuttng the sample.
(5) Press the
[TEST] key to dsplay the cuttng test selecton screen.
FORCE
TEST1
SAMPLE
SPEED
(6) Press the [F3] key (SAMPLE) to dsplay the sample data selecton screen.
FORCE
SELECT SAMPLE DATA
CUTTING PRO
SPEED
3-22
] [
] [
] keys to move the tool carrage (the tp of the tool selected by the current settng)to the
OFFSET
TEST2
BLADE ADJ.
QUALITY
Appropriate
(+1 to +5)
] [
] [
] keys to move the tool carrage (the tp of the tool selected by the current settng) to the
OFFSET
TEST2
BLADE ADJ.
QUALITY
OFFSET
OTHER
QUALITY
Excessive creasing force
Reduce the creasing force
(-1 to -5)
[ENTER] key or the
[NEXT] key.
Advertisement
Table of Contents
