Brother FAX-8350P Owner's Manual page 150

140
C H A P T E R S I X T E E N
Sending Faxes
Handling
Incoming
Calls
General
Printing
Difficulties
(For MFC-9650/
FAX-8750P only)
DIFFICULTY
Poor transmitting quality
Transmission verification
prints "Results:NG"
When the receiving party
says the picture is not clear your fax may not have been appropriate. Send the fax again,
When the receiving party
says vertical streaks appear print head may be dirty. Clean your scanner and make a
on the faxes they receive
F/T pseudo-ring in Fax/Tel The machine knows the incoming call is not a fax so it is
(F/T) Mode.
Transferring a fax call to
the machine.
The machine does not print. Make sure the machine is plugged in. The toner cartridge
The machine prints
unexpectedly or it prints
garbage.
The machine cannot print
full pages of a document.
The machine prints the first Your computer is not recognizing the printer's "input buffer
couple of pages correctly,
then some pages have text
missing.
The machine cannot print
full pages of a document.
A MEMORY FULL error the number of font sizes within your application software.
message occurs.
SUGGESTIONS
Try changing your resolution to FINE or SUPERFINE
(see chap. 6) Make a copy to verify the machine's scanner
operation.
There is probably temporary noise or static on the phone
line. Try sending the fax again. If the problem continues, call
the Telephone Company to check your phone line.
Sometimes the resolution mode you chose when you sent
but try using the FINE or SUPERFINE mode. Also, your
machine's scanner may be dirty, so try cleaning it.
Your machine's scanner may be dirty or the receiving party's
copy to check if the problem was caused by your machine.
signalling you to answer the telephone call. Pick up the
external telephone's handset and press Tel or answer from
an extension phone and press your machine's Deactivation
Code (default setting is #51).
If you answered at the machine, press Start and hang up
immediately. If you answered at an extension phone, press
your Remote Activation Code (default setting is 51). When
your machine answers, hang up.
and drum unit are installed properly. The interface cable is
securely connected between the machine and computer.
Check to see if LCD is showing an error message.
Unplug it. Make sure your application software is correctly
set up to use the machine by checking the primary settings
in your application software.
The machine received a very complex print job and could
not process part of the page. This may be solved in several
ways. If you are using Windows
Workstation Version 4.0 with the supplied printer driver,
®
see the "Windows Setup Printing Problems" section.
Try to reduce the complexity of your document or reduce
print resolution.
full" signal. Please make sure you connect the printer cable
correctly.
Reduce the printer resolution. Reduce the complexity of your
document and try again. Reduce the graphic quality or
Expand the printer memory by installing one of the optional
memory boards. (For FAX-8350P/MFC-9650 only)
® ®
95, 98 or Windows NT