Getting Ready To Use; Installing And Replacing The Battery Pack - Casio IT-G600 Series User Manual

No. Name
27 Reset Switch
28 nanoSIM Card Slot
Power Supply/
29
Data Communication Terminals

Getting Ready to Use

* In the step 3, be sure to charge the battery pack completely.
1. Confi rm that all the items listed on page 12 are included in the package.
2. Install the supplied battery pack in the terminal. (→page 18)
3. Charge the battery pack. (→page 23)
4. Turn the power on. (→page 34)

Installing and Replacing the Battery Pack

Your terminal uses two types of battery: a battery pack and a memory backup battery.
The battery pack is used to power normal operations and to store data, while the memory
backup battery provides the power required to maintain memory contents when the battery
pack power is unable to supply power for some reason. You can use the HA-U20BAT
battery pack with this terminal.
The backup battery is installed inside of the terminal.
This guide uses the following terms to refer to the batteries.
Battery Pack:
Backup Battery: Built-in battery for memory backup
When the terminal's battery pack is low on charge, the charging status LED fl ashes orange.
When the battery pack power goes low, immediately charge it or replace it with a charged
battery pack.
The battery pack can be charged using the Multiple Battery Charger, Dual Battery Charger,
USB Cradle or Ethernet Cradle.
See the relevant sections in this guide for the respective options about how to use.
Important!
Always keep backup of all important data!
• The battery pack powers normal operation and also provides power required to
maintain memory contents, while the backup battery provides backup power to
maintain memory contents. Because of this, you should not remove the battery pack
if the backup battery is dead. Removing the battery pack while the backup battery is
dead causes data in the memory to be corrupted or lost. Note that once data is lost it
cannot be recovered. Always keep backup of all important data.
18
Performs a hardware reset.
Used to load a nanoSIM card.
Connects to the terminals in a cradle or similar device to supply
power or enable USB communication.
Rechargeable battery pack (HA-U20BAT) for normal operations and data
storage
Description