Getting Started - BALDR B0389WST2H2-V1 User Manual

BALDR recommends high quality alkaline or lithium batteries
for the best product performance. Heavy duty or rechargeable
batteries are not recommended.
MAIN UNIT INSTALLATION
Powered by AC Adaptor:
Connect the power adaptor with DC hole on side of the main unit and
plug the adaptor to a powered outlet.
Powered by batteries:
1. Remove the battery compartment cover.
2. Insert 3x AAA battery matching the polarity(+and-).
3. Replace the battery cover
SENSOR INSTALLATION
1. Remove the battery compartment cover.
2. Insert 2 x AA batteries in each sensor matching the polarity (-+and-).
3. Replace the battery cover.
SENSOR SETUP
● Power the main unit prior to load the batteries of sensor.
● Switch the button of 3 sensors to CH1 , CH2 and CH3. For example,
you can set to Channel 1 for the sensor. But please ensure the main
unit are set to the same channel before synchronization. (Special
note: Press."
setting order is CH1--CH2--CH3--Channel scan（from CH1 to CH2 to
CH3,Channel scan with 5 seconds intervals）,you must select the
same number choices for both the sensor and the main unit in order to
synchronize).

GETTING STARTED

'' button on the main unit to set the channel. The
/CH
9