Development Board Leds - Digi Connect EM Hardware Reference Manual

D e v e l o p m e n t B o a r d L E D s
GPIO Switch Bank 1 (SW1) and 2 (SW2)

Development Board LEDs

3 4
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
GPIO Switch Bank 1 and Switch Bank 2, labeled SW1 and SW2, are two sets of five slide
switches that set GPIO inputs to logic levels of high (switch to left) or low (switch to
right).
If the GPIO port is configured as an output, then the switch should always be to the left. If
there is an external device connected to P3, the switch should always be set to the left.
Each GPIO port can be used independently.
Notes:
These switches do not determine whether the GPIO is an input or output. That
is determined by the module software.
If GPIO is set to an output by software, switches must be set to the left (high).
These switches are used in conjunction with SW3 and SW4.
The development board contains 21 LEDs labeled CR1 through CR21. The following table
lists and describes the LEDs.
Board
Description
Label
CR1
CR2
CR3
D i g i C o n n e c t E M & W i - E M H a r d w a r e R e f e r e n c e
LED Descriptions
Color or State
Flickering
TXD-2
Green
Flickering
RXD-2
Green
Yellow
Green
CTS
Off
Indication
Serial activity
Inactive
Serial activity
Inactive
Active
Inactive
Not connected or signal
not being driven