Table of Contents
Advertisement
14/104
A4... with HS5E(V)(L) control system Series 1x and 30 | Safety instructions
Bosch Rexroth AG, RE 92076-01-B/2021-04-22
System/machine under pressure!
Risk of death or serious injury when working on unsecured machines/systems!
Property damage!
▶ Switch off the relevant machine/system part and secure these against
reactivation according to the parameters by the machine/system manufacturer.
▶ Ensure that all relevant components of the hydraulic system are depressurized.
For this purpose, observe the parameters indicated by the machine/system
manufacturer.
▶ When working at hydraulic systems with stored pressure energy
(e.g. accumulators), hydraulic components may even be pressurized after the
pressure supply has been switched off. During work, hydraulic fluid may escape
or hydraulic components may fly around and cause serious injuries. Before
starting work at the system, ensure that the hydraulic system is depressurized.
▶ Please note that the hydraulic system might still be pressurized even after
separation from the actual pressure supply.
▶ Do not disconnect any line connections, ports or components as long as the
hydraulic system is under pressure.
Escaping hydraulic fluid mist!
Risk of explosion and fire hazard, health hazard, risk of environmental pollution!
▶ Depressurize the relevant machine/system component and repair the leak.
▶ Only perform welding work when the machine/system is depressurized.
▶ Keep open flames and ignition sources away from the axial piston unit.
▶ If axial piston units are located in the vicinity of ignition sources or powerful
thermal radiators, a shield must be erected to ensure any escaping hydraulic
fluid cannot be ignited, and to protect hose lines from premature aging.
Hydraulic fluid will explode when making contact with water!
Risk of explosion and fire!
▶ Do not bring hot hydraulic fluids in contact with water.
Electrical voltage!
Danger to life or risk of injury due to electric shock or property damage!
▶ Always diskonnect the voltage supply to the relevant machine/system part
before assembling the product and/or connecting or diskonnecting the
connector. Protect the machine/system against being re-energized.
WARNING
Advertisement
Table of Contents
