Assembly - HAMPTON BAY METARIE II 24 Use And Care Manual

Assembly

1
Preparing the canopy
Remove the canopy bottom cover (C) from the canopy (B) by
turning the canopy bottom cover (C) counterclockwise.
Remove the mounting bracket (A) from the canopy (B) by
removing the non-slotted canopy mounting screws (GG)
from the bottom of the canopy (B) and loosening the slotted
canopy mounting screws (GG) a half turn from the screw
head. Next, turn the canopy (B) counterclockwise to remove
the mounting bracket (A) from the canopy (B).
GG
3
Assembling the fan
WARNING: Failure to properly install the cotter pin (HH)
could result in the fan loosening and possibly falling.
NOTE: If a longer downrod (not included) is needed, take out
the screw located in the hanger ball, lower the hanger ball
and remove the pin. Remove all three pieces from the
downrod and assemble them onto the new longer downrod
before proceeding to the downrod installation.
Route the wires exiting from the top of the fan motor
assembly (E) through the canopy bottom cover (C). Ensure
the slot openings are on top.
Route the wires through the canopy (B) and then through
the hanger ball/downrod assembly (D).
Align the holes at the bottom of the hanger ball/downrod
assembly (D) with the holes in the collar on top of the fan
motor assembly (E).
Carefully insert the clevis pin (II) through the holes in the
collar and the hanger ball/downrod assembly (D). Be careful
2
A
B
GG
C
8
Preparing the motor
Remove the cotter pin (HH) and clevis pin (II), and loosen the
two collar setscrews (JJ) from the motor collar.
HH
not to jam the clevis pin (II) against the wiring inside the
hanger ball/downrod assembly (D).
Insert the cotter pin (HH) through the hole near the end of
the clevis pin (II) until it snaps into the locked position.
Tighten the two collar setscrews (JJ) on top of the fan motor
assembly (E) firmly.
II
II
JJ
JJ
D
B
C
HH
JJ
E
JJ