Table of Contents
Advertisement
2.Lower the Media Set Lever of the CE7000-40.
2. Pull out the tip of media to the front of Push Roller on the CE7000-40.
And then shift the position of the F-Mark2 so that the crop mark on the Test Cut sheet under the
Camera.
Camera
Crop mark
3. Launch the iMark Plus software, and then fine adjust the position of the F-Mark2 so that the crop
mark which displayed on the iMark Plus software window is displayed on the center of the window.
- 44 -
Advertisement
Table of Contents
Need help?
Do you have a question about the F-Mark 2 and is the answer not in the manual?