Page 1
International registered trademark n. 2.777.971 LYRA, JACK 1600 Underground hydraulic operator JACK JACK CARRYING BOX LYRA INSTALLATION MANUALS AND SAFETY INFORMATION SEA USA Inc. 10850 N.W. 21st unit 160 DORAL MIAMI Florida (FL) 33172 Phone:++1-305.594.1151 Fax: ++1-305.594.7325 Toll Free: 800.689.4716 web site: www.sea-usa.com...
RELEASE MOUNTING ........................13 ADJUSTABLE MECHANICAL STOPS ....................13 CABLE LAYOUT ..........................14 RISK EXAMINATION ...........................15 PERIODICAL MAINTENANCE ......................15 ACCESSORIES FOR JACK ........................15 HYDRAULIC UNIT RELEASE SYSTEM ....................16 RELEASE SYSTEM OF THE LEAVES....................16 C) SALES CONDITIONS and WARRANTY ....................17 67411785 REV 00 - 03/2014...
LYRA, JACK International registered trademark n. 2.777.971 Details General An appliance shall be provided with an instruction manual. The instruction manual shall give instructions for the installation, operation, and user maintenance of the appliance. The installation instructions shall specify the need for a grounding-type receptacle for connection to the supply and shall stress the importance of proper grounding.
Page 4
LYRA, JACK International registered trademark n. 2.777.971 g) The Stop and/or Reset button must be located in the line-of-sight of the gate. Activation of the reset control shall not cause the operator to start. h) A minimum of two (2) WARNING SIGNS shall be installed, one on each side of the gate where easily visible.
PRECAUTIONS GATE WARNINGS The first thing to check is that the gate is in good running order as LYRA, JACK has been created for the automation of gates used by follows: vehicles only. Be aware to avoid the crossing of the gate path because it is very dangerous for pedestrians (fig.
LYRA HYDRAULIC UNIT The LYRA JACK consists of a hydraulic pump and a hydraulic jack. The jack is placed inside a non carrying or carrying box (inox only for carrying box). The pump unit casing, which is used as an oil tank, contains the electric motor, fluid pump, distributor and hydraulic oil.
4. MOUNTING OF THE LEAF ON NON- CARRYING BOX 4.1. Insert the broached bush on the shaft of the jack. Turn the shaft of the jack toward closing until it stops. WARNING: For operators with brake make sure that the jack has reached the stop and not the beginning of the slowdown.
5 . H Y D R A U L I C U N I T B O X W A L L and 21) and make sure that the shaft corresponds to the INSTALLATION (Fig.23) rotation axis of the jack. Fig. 19 Fig. 23 5.1.
*The operator is adjusted at 33 pound force ex works so to guarantee the anti-crush safety. During the connection phase between hydraulic unit and jack, air We recommend to adjust it only in case of necessity. will inevitably enter into the system and cause an irregular operation of the operator.
2/3 opening and closing cycles. i) Replace the oil from the oil filler cap. Any top-ups should be performed only with oil SEA 0x29 (supplied). 10.2. Inside the excavated pit you have to plan: - rain water drainage;...
LYRA, JACK International registered trademark n. 2.777.971 MECHANICAL INSTALLATION holes, furthermore it is necessary to respect the perpendicularity Fig. 36 to the axe of rotation (Fig. 39) Fig. 39 10.4. Introduce the buckle of creeping in the box and fix it with the special screws (Fig.
SEA control unit. 14. ADJUSTABLE MECHANICAL STOPS Fig. 44 N.B.: If the Jack is not installed immediately but in a second time, it is recommended to weld the crank shaft and the crank during the installation of the Jack.
LYRA, JACK International registered trademark n. 2.777.971 MECHANICAL INSTALLATION 18. ACCESSORIES FOR JACK 16. RISK EXAMINATION The points pointed by arrows in fig. 56 are potentially dangerous. The installer must take a thorough risk examination to prevent crushing, conveying, cutting, grappling, trapping so as to guarantee a safe installation for people, things and animals.
LYRA, JACK International registered trademark n. 2.777.971 MECHANICAL INSTALLATION To the attention of users and technicians 20. RELEASE SYSTEM OF THE LEAVES 19. HYDRAULIC UNIT RELEASE SYSTEM RELEASE 19.1. To release do as follows: 20.1. To release act as follows: - Open the door with the delivered special key.
SEA. Recognized defects, whatever their nature, will not produce any responsibility and/or damage claims to SEA USA Inc and SEA s.r.l. Warranty shall not cover any required labor activities. Warranty will in no case be recognized if alterations and any other changes will be found on products. Warranty will not cover damages caused by carriers, expendable materials and faults due to improper use with the products specifications.
Page 20
® International registered trademark n. 2.777.971 SEA USA Inc. 10850 N.W. 21st unit 160 DORAL MIAMI Florida (FL) 33172 Phone:++1-305.594.1151 Fax: ++1-305.594.7325 Toll Free: 800.689.4716 web site: www.sea-usa.com e-mail: sales@sea-usa.com...
Need help?
Do you have a question about the JACK and is the answer not in the manual?
Questions and answers