Table of Contents
Advertisement
4. INSTALLATION
It is advised that the installation of the boiler is done by a specialist. Improper installations may
cause breakdown and damages where the manufacturer cannot be held responsible.
For safety, proper grounding must be done for electricty installation.
It is forbidden to make changes or additions to the original design. Any modified boiler is out
of scope of guarantee.
ATTENTION! Please do not install the boiler to closed areas of human presence. In time there
might arise the risk of poisonous gases spreading to the area as a result of clogged flue or other
problems.
In order to supply fresh air to the installation site , air ducts is a necessity to avoid the
formation of poisonous gases.
The boiler must be installed in a secure location, unaffected by weather conditions. This will
protect the boiler and the system from frost and also reduce heat losses while increasing the
efficiency.
A minimum 10 cm high brick statue to be prepared at the base of the installation site is a
necessity for protecting the boiler from water flood and rusting of the sheet material.
The installation site must at least have 75 cm empty space as the installation inlet is at the back
of the boiler.
Chimney connection must be connected with long meterage pipes with maximum 2 elbows.
Chimney connection must be done in such a way that it can be easily demounted and will not
allow gas leak.
Advertisement
Table of Contents
