Table of Contents
Advertisement
o flame the coal, please add wood pieces on the coal and burn the fuel from the top with diesel.
T
Please close the boiler doors and turn on main switch. The boiler will gradually burn since the
air is supplied through the fan. Do not open the boiler doors when the burning is still going on.
In case of a necessity, the doors might be opened after stopping the fan.
During first operatinon, we suggest to set the temprature of control thermostat to a high degree
(70 C). You may set the thermostat to desired temprature for later uses.
When the boiler reaches to 40 degrees, the circulation pump will function. This will avoid
unnecesary electricity consumption and damages as a result of instant heating.
In case of a frost below 0 degrees, the system shou ld continue to function , otherwise the
system water must be drained.
The fan will continue to function until the sytem water temprature reaches to set values on
control thermostat. At this value, the fan will stop and the circulation pump continues to function.
In this case, you can see what temprature is the boiler water. You can monitor desired temprature
value by pushing and releasing the control thermostat button.
When the fan speed settings change, speed setting value appears on the screen.Then the boiler
water temprature continues to be seen.
The boiler temprature will continue to decrease when the fuel inside the boiler is finished. Even if
the control thermostat is set to high temprature, the pump will stop to functon after the system
water drops down to 35 degrees ans circulation pump will stop running. When temperature drops
down to 25 degrees, fan will stop running and system shuts down. In this case please add fuel and
press ON/OFF button for 2 seconds ,close the system and then press again for 2 seconds to turn
on the system.
NOTE: During long term use, please move the mechanism handle to right and left in order to
supply air to unburned fuel.
Advertisement
Table of Contents
