Advertisement
StartUSB for AVR
STEP 6: MCU programming
After the MCU programming is completed, the Atmel FLIP window will become inactive.
NOTE: When the MCU programming is finished, remove jumper J3 (ENABLE BOOT) from the StarUSB for AVR
development system. Otherwise, the system will reenter bootloader mode .
After the .hex file is loaded, an information
about it will appear in the Atmel FLIP window
Information that .hex file is parsed
Click on the Run button
Click on the Start Application button
Information that .hex file verification is passed
Information that link with StartUSB for AVR is
disabled (Communication OFF)
MikroElektronika
7
Advertisement
Need help?
Do you have a question about the StartUSB for AVR and is the answer not in the manual?